Adding cover plate to rear of cabinet, 14 servicing, Installation instructions – GE 500A436P006 User Manual
Page 8: Call toll-free, Servicing
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
installation instructions
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
* Insert the elbow through the rear opening and connect
it to the dtyer internal duct.
* Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ADDING COVER PLATE TO REAR
OF CABINET
PLATE
(KITWE1M454)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider.
Place dryer in final location.
A WARNING - NEVER LEAVE THE
BACK OPENING WITHOUT THE PLATE.
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1
-
888
-
269-1192
Prompt registration confirms your right to protection under the
terms of your warranty.
For Questions on Installation, Call: 1-800-626-2000 (US) or
500A436P006
1-800-561-3344 (Canada). Pub.#
31-16225
8
14
SERVICING
A
WARNING - LABEL ALL WIRES
PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INSTALLATION.
For replacement parts and other infonnation, refer to
Owner's Manual for servicing phone numbers.