M dryer exhaust to left or bottom cabinet, Tab location, Adding new duct – GE 500A436P006 User Manual
Page 7: Installation instructions, Dryer exhaust to left or bottom cabinet
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions
m
DRYER EXHAUST TO LEFT OR
BOTTOM CABINET
^ WARNING - BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES
REMOVE
SCREW
AND SAVE.
P
REMOVE /
DESIRED
KNOCKOUT
(ONE ONLY).
Detach and remove the bottom or left .side knockout as
desired. Remove the screw inside the dtyer exhaust duct
and save. Pnll the duct out of the dtyer.
FIXING HOLE
\
B
A ^
I
---------- 9' ---------- ►
Cut the duct as shown and keep portion A.
TAB LOCATION
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45° using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
LEFTSIDE
EXHAUST
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. LTse the screw saved previously to secure
the duct in place throngh the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, throngh the side opening
and connect the elbow to the dtyer internal duct.
CAUTION: Be sure not to pull or damage the
electrical wires inside the dryer
when inserting the duct.
Apply duct tape as shown on the joint beuveen the dtyer
internal duct and the elbow.
DUCT
TAPE
CAUTION:
Internal duct joints must be
secured with tape, otherwise
they may separate and cause
a safety hazard.