GE JRP14 - Manual (Page 7)

OVEN CONTROL, CLOCK AND TIMER
'^lock
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Bake or Self-Clean cycle.
To Set the Clock
1. Press the CLOCK pad.
2. Press the INCREASE or DECREASE
pad to set the time of day.
n
C
O
1-^
c
O
ft
n
o
0
3
Timer
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
is 9 hours and 55 minutes.
To Set the Timer
1. Press the TIMER
ON/OFF pad.
2. Press the INCREASE
or DECREASE pad
to set the amount of
time on the timer.
The timer will start automatically
within a few seconds of releasing the
INCREASE or DECREASE pad. The
timer, as you are setting it, will display
seconds until one minute is reached.
Then it will display minutes and
seconds until 60 minutes is reached.
After 60 minutes, it will display hours
(“HR” now appears in display) and
minutes until the maximum time of
9 hours and 55 minutes is reached.
To Reset the Timer
If “TIMER” is displayed, press the INCREASE or
DECREASE pad until desired time is reached.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word “TIMER” disappears from the display.
o
fD
0
n
§
3^
n
o
to
0
&
H
3
ft
End of Cycle Tone
The end of cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
Display Messages
• If “door” appears in the display, LOCK flashes
and the oven control signals, you set the self-clean
cycle and did not shut the door.
• If “door” only appears in the display, the oven
door is open and needs to be closed.
• If “LOCK” only appears in the display, the
oven door is in the locked position. BAKE,
BROIL and COOK TIME cannot be set if the
door is in the locked position.
Power Outage
■After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
The display flashes until the clock is reset. All other
functions that were in operation when the power went
out will have to be programmed again.