GE 52060 GE Electrical Circuit Tester - Manual

Circuit Tester
Know if outlets are "live"
52060
Important: When using, be careful not to touch live wires or the metal leads of
the tester. This is not a diagnostic instrument and is not intended to detect a
combination of defects in a wiring circuit. It is a simple tester for detecting the
presence of voltages between 90 and 300 volts. Voltages less than 90 volts may
be present but may not be detected by this device. Any indication of wiring faults
should be referred to a quolified electrician for correction.
How to Test Outlets:
Determine if the circuit is live by inserting
the tester leads into the outlet slots.
Tester will glow if circuit is live.
Check 0 3 SLOT-120VAC grounding outlet
by inserting one lead into the hot
(narrow) slot and the other lead into the
U-shaped ground slot. Tester should
glow. Then test between wide side
(neutral) and "U" shaped (ground). Tester
should NOT glow.
Check a 2-SLOT-120VAC outlet by
inserting one leod into the hot (narrow)
slot and the other into the wide slot.
Tester should glow. To determine hot
wire on 2 wire circuits, insert one probe
into the narrow slot and touch the other
probe to the metal mounting screw or
metal plate. If screw is grounded, tester
will glow. Remaining slot is the neutral.
3 SLOT-240VAC Receptacles: Test for
normal (llOV) glow between round hole
(ground) and either hot side. Note
brighter glow (220V) across both hot
sides.
Note: If circuit is properly grounded,
tester will glow with same brightness os
for live circuit. If brightness is less for
ground slot, refer the condition to a
qualified electrician.
Made in China
' is a trademark of General Electric
Company and is used under license to
Jasco Products Company LLC,
311 N.w. 122nd street, Oklahoma City.
OK 7311A. www.jascoproducts.com
IN52060-1 REV 1/13/2006 GE2598-01D
Ground
LISTED
96TJ
Voltage
Tester
A WARNING
Risk of electric shock
• Use eMtrerre caution v^«n
checkhg k'eelectricolcrcuits
• OonothoUrreulportof
(ester ^ods