COBY CX-CD400 - Manual (Page 4)

GENERAL OPERATION
POWER SOURCES Before connecting the Unit to an AC outlet, check that the
operating voltage of the Unit is identical with the voltage of your local power supply.
Connect the supplied AC power cord to the AC in jack.
BATTERY OPERATION Switch the AC/DC selector to DC position. Open the
Battery Compartment Door and insert 8 UM-1 D size batteries, making sure that
the indicated battery polarity is observed. Note: The AC cord must be completely
disconnected if no AC/DC selector switch.
RADIO OPERATION Slide the Function Switch to the RADIO position. Slide the
Band Switch, as you prefer. Turn the tuning knob to your desired radio station.
Adjust the Volume Controls.
SPEAKER PLACEMENT This unit features a detachable speaker system. The left
and right speaker enclosures can be detached from the main unit, and placed
where desired. When the speakers enclosure are attached to the main unit, the
unit can be carried to any location desired.
TO ATTACH THE SPEAKER ENCLOSURES
1
Attach the speaker enclosure to the main unit about halfway up, and slide
the speaker enclosure to the locked position.
2
Extend the speaker wire to the desired length.
3 Insert the speaker wire plug into the SPEAKER JACK.
TO DETACH THE SPEAKER ENCLOSURE
1
Remove the speaker wire plug from the SPEAKER JACK.
2 Push the RELEASE lever as illustrated and lift the speaker enclosure.
3 Wind the excess speaker wire onto the post, on the back of each speaker
enclosure.
FM STEREO INDICATOR Slide Band Switch to FM position, The FM Stereo
indicator is on if stereo broadcasts are received.
ANTENNAS Fully extend the Telescope Antenna to receive FM and SW (Option)
stations. For AM reception the unit has a built-in antenna. Turn the whole unit for
best reception.