beautypg.com

Changing the light bulbs, Removing the base grille, Ià warning – Whirlpool 8ET20DK User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Changing the light bulbs

ià WARNING

Electrical Shock Hazard

Before removing a light bulb, either unplug

the refrigerator or disconnect the electricity

leading to the refrigerator at the main
power supply.

Failure to do so could resuK in electrical

shock or personal injury.

To change the refrigerator light:

1. Disconnect refrigerator from power supply.

2. Reach behind the Control Panel to remove

bulb.

3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.

To change freezer light (ET22DM and

ET22DK):
1. Disconnect refrigerator from power supply.

2. Grasp the top and bottom of the light shield.
3. Squeeze and pull light shield out.
4. Replace with a 25-watt appliance bulb.
5. Snap light shield into place.
6. Reconnect refrigerator to power supply.

NOTE: Not all commercial appliance bulbs will fit

your refrigerator. Be sure to replace a bulb with
one of the same size and shape.

Removing the base grille

To remove the grille:

1. Open refrigerator door.

2. Pull base grille forward to release the support

tabs from the metal clips.

3. Do not remove Tech Sheet fastened behind

the grille.

To replace the grille:

1. Line up grille support tabs with metal clips.

2. Push firmly to snap into place.
3. Close refrigerator door.

See cleaning instructions for defrost pan and
condenser coils on page 16.

Condenser coils

13