What happens in each cycle, Self-cleaning lint filter, The washer pauses briefly throughout each cycle – Whirlpool 3366859 User Manual

Page 9: Wash rinse

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATING YOUR WASHER

What happens in each cycle

When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating

immediately after filling; agitation can occur

with the washer lid up or down.

After agitation starts, the Cycie Controi Knob
turns clockwise untii it points to an OFF area
and the cycle ends.

The washer pauses briefly throughout

each cycle.

These pauses are normal for

washer operation.

WASH

RINSE

Fill

^.....

Fill

Wash selected time

Rinse

Drain (or partial drain*)

No agitation

Drain-No agitation

‘The Permanent Press cycle partially
drains, fills, agitates briefly, and drains.

Spin-Spray rinse

Spin

Off

Self-cleaning lint filter

The lint filter at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is

then spun away from the filter and out of the

system during the spin part of the cycie.

If your washer drains into a tub, remove

any lint collected in the tub or strainer.