Install properly, Remove sales labels, Level chest freezer – Whirlpool EH090F User Manual
Page 4: Level chest freezer remove sales labels, Install properly... remove sales labels
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Install properly...
Remove sales labels...
Remove any labels before using the freezer.
To remove any remaining giue:
1, Rub briskly with thumb to make a ball, then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step 1.
DO NOT USE rubbing alcohoi or flammable or
toxic solvents, such as acetone, gasoline, car
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet on inside
of compressor compartment door.
1, Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2 Pick a safe place, indoors, away from in
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm] air space on all
sides of freezer and 2 inches (5 cm] at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad
justment, see your authorized WHIRLPOOL dealer.
5 Do nof cover fhe freezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezer...
from end to end and front to back so that the lid will
seal properly
Check with level
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit sen/ing
only this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
.Attach retaining clip over power cord plug from
literature package inside the freezer.
See individual electrical requirements and ground
ing instruction sheet in your literature package.