Install properly, Remove sales labels, Plug it in – Whirlpool EV0G0F User Manual

Page 4: Remove soles labels, Level freezer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Install properly...

1. Check the strength of the floor It should hold the

weight of a fully loaded freezer

Pick a safe place, indoors, away from inflam
mables such as gasoline.

Spacers are packed in the freezer. Install them as
shown to keep freezer at least 2 inches [5 cm) from
the wall

Remove the shipping block.
Allow at least 3 inches (7,5 cm] air space on top
and each side of the freezer.

Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.

Level freezer...

1, Slide freezer into place,
2, Level freezer using wood shims sofhat door wil

open at any position.

stay

Remove sales labels...

Remove any labels before using the freezer.

To remove any remaining glue:

1, Rub briskly with thumb to moke a ball, then

remove

2 Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) be

fore removing glue as described in step 1

DO NOT USE rubbing alcohol or flammable or

foxic solvenfs, such as acefone, gasoline, car

bon fefrachloride, efc. These can damage the
material.

NOTE: DO NOT REMOVE the Tech Sheet on the

back of the cabinet.

Plug it in...

Recommended Grounding Method

A115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a

receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord. See individual "Electrical Requirements and
Grounding Instructions” provided with your

product.

Attach retaining clip over power cord plug from

literature package inside the freezer.