Whirlpool BYCD3722W0 - Manual (Page 8)

OPEMünNCYOURDlHgt
To get the best dryer results possible, you must use your dryer correctly. This section tells you how
to use your dryer properly and efficiently.
STAMINC YOUR DRYER
^WARNING AWARNING
M
Fire Hazard
Explosion Hazard No washer can completely remove oil.
Keep flammable materials and vapors, Do not dry anything that has ever had any
such as gasoline, away from dryer. type of oil on it (including cooking oils).
Do not dry anything that has ever had Items containing foam, rubber, or plastic
anything flammable on It (even after must be dried on a clothesline or by using
washing). an Air Cycie.
Failure to follow these instructions can Failure to follow these instructions can
result in death, explosion, or fire. resuit in death or fire.
Before using your dryer, wipe the dryer drum with a
damp cloth to remove dust from storing and shipping.
If your dryer has a Features Guide, remove it and
place it with this Use and Care Guide.
1. Load clothes loosely into the dryer and cióse the
door. Do not pack the
dryer; allow space for
clothes to tumble freely.
3. If your dryer has a Temperature selector, set it to
the recommended setting for the type of fabric
being dried. The cycle descriptions on the
following pages include temperature setting
suggestions.
4. (OPTIONAL STEP) If your dryer has a Cycle
Signal (End of Cycle Signal) selector, set the
selector to On if you want the dryer to sound
a signal when a cycle is finished.
• The signal is helpful when you are drying
permanent press, synthetics, and other items
that should be removed from the dryer as
soon as it stops.
• On some models, the End of Cycle Signal is
part of the Start button.
5. Push the Start Button.
2. Turn the Cycle Control Knob to the recommended
cycle for the type of load
being dried, as described
in “Cycle descriptions”
later in this section.
• Use the Energy
Preferred Automatic
Setting (*) to dry most
loads.
NOTE: On some models,
the Temperature selector
is part of the Cycle
Control Knob. NOTE: Your dryer stops automatically when a
cycle ends.