Removing the base grille, Changing the light bulbs, Electrical shock hazard – Whirlpool 3ED22DQ User Manual

Page 20: To change refrigerator light

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

USING YOUR REFRIGERATOR

Removing the base grille

To remove the grille:

1. Open both doors.

2. Pull base grille forward to release the

support tabs from the metal clips.

3. Do not remove Tech Sheet fastened

behind the grille.

To replace the grille:

1. Line up grille support tabs with metal

clips.

2. Push firmly to snap Into place.

3. Close the doors.

See cleaning instructions for defrost pan and
condenser coils on page 24.

Condenser coils

Metal

clips

Base
grille

Support

' tabs

Changing the light bulbs

^WARNING

Electrical Shock Hazard

Before removing a light bulb, either
unplug the refrigerator or disconnect

the electricity leading to it at the main

power supply.

Failure to do so could result in per

sonal injury.

To change refrigerator light:

1. Disconnect refrigerator from power supply.

2. Reach behind the Control Console to

remove bulb.

3. Replace bulb with a 40-watt appliance bulb.

4. Reconnect refrigerator to power supply.

To change crisper light:

1. Disconnect refrigerator from power supply.

2. Pull top of light shield forward until It snaps

free.

3. Lower light shield to clear bottom supports.

4. Pull light shield straight out to remove.

5. Replace bulb with a 40-watt appliance bulb.

6. Replace light shield in reverse order.

7. Reconnect refrigerator to power supply.