Whirlpool WU5750 - Manual (Page 6)

U S I N G Y O U R D I S H W A S H E R
Using Your Dishwasher
In This Section
Page Page
Before starting your dishwasher ..... 6 Using delay wash............................ .... 10
Starting your dishwasher................ ..... 6 Using the detergent dispenser... .... 10
Adding a dish during a cycle........... ...... 7 Using the rinse agent dispenser .... 11
Changing a cycle setting................. ......7 Quiet operating tips......................... .... 12
Canceling a cycle............................ ...... 7 Water temperature tips.................... .... 13
Changing an option......................... ...... 8 Energy saving tips.......................... .... 13
Cycle selection chart....................... ...... 8 Special tips on dishwasher use .... 14
What happens in each option.......... ...... 9
Operating your dishwasher properly enables you to obtain the best possible results. This
section explains proper dishwasher operation.
Before starting your dishwasher
1. Properly load the top rack, bot­
tom rack, and the silverware bas­
ket. See pages 15-17.
2. Spin the lower spray arm with
lower rack in place to make sure
nothing prevents arm from turn­
ing freely.
3. Add detergent. See pages 10
arxl 11.
4. Check the rinse agent dispen- n
ser. See pages 11 and 12. 4
i
5. Push door firmly when closing E
and it will automatically latch. ^
6. Run hot water at sink nearest
dishwasher until water is hot. i
Turn off water. -
Starting your dishwasher
The dishwasher will wash and dry dishware according to the selections you make on the
control panel.
1. Select a drying option. See page 9 for
description.
NOTE: Select ENERGY SAVER or EN­
ERGY SAVER DRY for the Rinse & Hold
cycle.
For models with three buttons, the Heat
Dry option is automatically selected with the
Pots & Pans cycle.
2. For models with three buttons:
If the Pots & Pans cycle will be used, push
POTS & PANS button.
on some models on some models