Important, Contents page, Before you plug it in – Whirlpool EC5100 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Contents
Page
BEFORE YOU PLUG IT IN........................... 3
USING YOUR ICE MAKER........................... 4
How the Ice Maker Works.......................... 4
Setting the Controls.................................... 4
CLEANING AND CARING FOR YOUR
ICE MAKER................................................... 6
Page
Cleaning Exterior Surfaces........................ 6
Cieaning the Condenser............................ 6
Cieaning the ice Maker System.............. 7
Cieaning the Interior Components ...
8
Filtering and Treating Water...................... 9
VACATION AND MOVING CARE............. 9
IF YOU NEED SERVICE OR ASSISTANCE 10
WHIRLPOOL ICE MAKER WARRANTY
12
c1987 Whirlpool Corporation
Before you plug it in
IMPORTANT
Before using your ice maker, you are
personally responsible for making sure that it...
• has been installed where it is protected from
the elements.
• is located so that the front is not blocked to
restrict incoming or discharge air flow.
• is properly leveled.
• is located in a well ventilated area with
temperatures above 55°F (13°C) and below
110°F (43°C). Best results are obtained
at temperatures between 70°F (21°C)
and 90“F (32“C).
is properly connected to a water supply and
drain.
is properly connected to electricity. A115
Volt, 60 Hz., 15 amp fused electrical supply is
required. NOTE: Time delay fuse or circuit
breaker is recommended,
is properly electrically grounded,
is notoperated by anyone unable to use
it properly.
is used only for the job it was designed to
perform.
is properly maintained.
NOTE: A drain pump kit (Model EKDP1) is avaiiabie as an option for installation where
a floor drain is inaccessibie.