Whirlpool ETIGJM - Manual (Page 6)

Adjusting the shelves.
1, First, remove food from shelf.
2, Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out
Replacing Shelf:
1. Fit book of shelf on top of guides with wire stops
on the bottom of guides
2. Lift front, siide shelf in until it clears guide stops
Removing crispers and crisper cover...
Removing the Crispers:
1, Slide crisper straight out to stop, lift front, then slide
the rest of the way out.
2. Replace in the reverse order
Removing Cover:
1. Lift front and remove the cover support.
2. Lift out cover by pulling up and out.
Repiacing Cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab towards
the front. Note: If support needs adjustment, turn
base right to lower, or left to raise.
Lift the Front, Then the Back
Í Front
Changing the light hulh.
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the eiectricity leading to the re-
trigerator at the main power supply.
Shock and injury can occur if elec­
tricity remains connected.
Remove bulb.
Replace with appliance bulb only
Automatic ice maker...
On
Raise Signal
Arm to Stop ice Maker.
Lower Signal
Arm to Start It.
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-83], there are a
few things you will want to know:
• The ON/OFF lever is a wire signal arm
Down,,.for making ice automatically;
Up...to shut off the ice maker.
• Shake the bin occasionally to keep cubes sepa­
rated, and to obtain increased storage capacity.
• It is normal for ice crescents to be attached by a
corner. They will break apart easily.
• You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you,
• The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight.
• Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
• If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward o
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
• If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
• If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
• The ice maker water supply should not be soft­
ened water. The chemicals could damage the ice
maker molds.