beautypg.com

Whirlpool AD0402XM0 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

1. To remove outer cabinet:

a. Disconnect power cord.
b. Take off the front plastic griiie. Remove the

two screws at the bottom. Drop griiie down
and take out.

TOP FLANGE
SCREWS

SOCKET HEAD
SCREWS

(Side of cabinet)

c. Remove the cabinet screws on each side

and top fiange screws (see iiiustration). On
30, 40 and 48 pt. modeis, also remove rear
grille. Pull out at bottom and drop grille
down.

d. Lift cabinet from unit.

2.

Coiis shouid be inspected annuaily. Brush ciean,

if necessary, with warm water and miid de­

tergent. Rinse and dry.

Be sure power supply

cord is disconnected.

WARNING: Be careful when
cleaning the condenser colls.
Hits are sharp and could cause
personal Injury.

COILS

3.

The compressor is sealed and needs no oiling.

However, the fan motor should be checked an­
nually and oiled.

OIL FAN MOTOR
(Bock Oil Hole
Not Shown)

4.

To oil fan motor, place a few drops of a good

grade oil in both oil holes located on the fan
motor. Oil capsules can be ordered (Part No.
10943) from your dealer.

5.

Wash plastic parts with a soft cloth, warm water

and mild detergent. Rinse and dry with a soft
cloth.

6

.

Replace cabinet grille(s). Reconnect power

supply cord.