Setting the water level control, Normal fill, Maximum fill – Whirlpool AD0402XM0 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Turn humidistat to UNIT OFF, then plug in the
dehumidifier.
2. Your dehumidifier has an automatic humidi
stat. Turn humidistat controi ieft towards DRYEST
for normal operation. Set at number 5 or 6 to
start. Adjust iater, if necessary.
When humidity in the room increases, the
dehumidifier automaticaily starts. When the
humidity decreases to the seiected ievei, the
dehumidifier automaticaliy stops.
3. If you need more dehumidification, turn control
to a higher number. Unit will run continuously at
DRYEST setting. If you need less, set on a lower
number.
4. Stop the unit manually by turning the control to
UNIT OFF.
Setting the Water Level Control
All models except the 12 pint (5.6 L) capacity model have an adjustable water
level control. The water level control can be set in two positions to automatically turn
off the unit when the pan is full. This prevents the danger of overflow.
Pan must be in proper position for water level control switch to work.
NORMAL FILL -
Water level adjustment set on the
left side indentation. The water
pan and water will weigh ap
proximately 16 lbs. (7.2 kg).
MAXIMUM FILL -
Move the water level control to
the raised area on the right side.
The water pan and water will
weigh approximately 24 lbs. (10.8
kg).
The water level control switch will automatically turn off the dehumidifier at the
fill level you selected. You may need to loosen the screw to move the water level
adjustment. Retighten screw when adjusted.