Whirlpool 3401011 - Manual (Page 10)

CARING FOR YOUR DRYER
Caring For Your Dryer
In This Section
Page Page
Maintenance-every load.................... ...........................1 0
Maintenance-as needed................. ...................10
Dryers require regular maintenance. Follow the suggestions below to maintain your dryer properly.
Maintenance-every load
Cleaning the lint screen
The lint screen is located under a lid on top of
the dryer. Clean it before each load. A screen
blocked by lint can increase drying time.
^CAUTION
Product and Fabric Damage Hazard
Do not run the dryer with the lint screen
loose, damaged, blocked or missing.
Doing so can cause overheating and
damage to both the dryer and fabrics.
1. Open the lid and pull the lint screen straight
out.
2. Roll lint off the screen with your fingers. Do
not rinse or wash the screen to remove lint.
Wet lint is hard to remove.
3. Push the lint screen firmly back into place
and close the lid.
Maintenance-as needed
Use the following suggestions about cleaning
and lint removal to help you keep your dryer
safe, looking like new, and at peak operating
efficiency.
Cleaning a clogged lint screen
Laundry detergents and fabric softeners can
cause a residue build-up on the lint screen. A
clogged lint screen can extend drying times.
Clean the lint screen every six months or more
frequently if it becomes clogged due to a
residue build-up. Use the following method:
1. Wet both sides of lint screen with hot water.
2. Wet a nylon brush with hot water and liquid
detergent.
3. Scrub lint screen with the brush until all
residue build-up is removed.
4. Rinse with hot water.
5. Thoroughly dry lint screen with a clean
towel and replace in dryer.
1 0