Clarion RS151 - Manual (Page 6)

Page 2 - RS151 Owner’s Manual
Remote Transmitter Layout
The Ungo RS151 comes with 2 Remote Transmitters used to control the system’s features. Each
time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking place.
Button 1 Locks the doors.*
Button 2 Unlocks the doors.*
Button 3 Activates the system’s auxiliary function (usually used for optional trunk release).*
Button 4 Remote starts the vehicle. It is also used to shutdown the engine if remote started.
*optional feature
Adding or Deleting Remote Transmitters
The Ungo RS151 has the ability to recognize 3 individual Remote Transmitters. If the vehicle is
used by multiple drivers, each can have their own Remote Transmitter.
To add a Remote Transmitter:
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
• The horn will honk 3 times.
• The LED will turn on.
3. Have all desired transmitters ready and follow the steps below for each transmitter.
For remote Locking with chirp confirmation continue holding the Override switch and
press Transmitter Button 1*.
--- or ---
For remote Locking without chirp confirmation release the Override switch and press
Transmitter Button 1*.
• The parking lights will flash once to confirm that the new Remote Transmitter has
been added.
4. Wait 5 seconds then turn off the ignition.
*Be sure that you press only Button 1. Pressing any other transmitter button will cause the unit to recognize the
individual transmitter buttons incorrectly.
Note: The RS151 will respond to only those remote transmitters learned during this procedure. Any previous remotes
will be deleted.
Remote Transmitters
Button 3
Button 1
LED
Button 2
Button 4
RS151OW1.QXD 6/27/2002 2:29 PM Page 2