Whirlpool AD0402XS0 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

. To remove outer cabinet:

Disconnect power cord.

Take off the plastic grille. Remove the two
screws at the bottom. Drop grille down and

take out.

TOP FLANGE
SCREWS

SOCKET HEAD
SCREWS
(side of cabinet)

c. Remove the socket head screws on each side

and top flange screws (see illustrations). On 30,
40 and 48 pt. models, also remove rear grille.
Pull out at bottom and drop grille down,

d Lift cabinet from unit.

Coils should be inspected annually. If needed,

brush clean with warm water and mild de

tergent. Rinse and dry. Be sure power supply
cord is disconnected.

WARNING: Be careful when cleaning

the condenser colls. Fins are sharp

and could cause personal Injury.

The compressor is sealed and needs no oiling

COILS

The fan motor is prelubricated and does not

require further oiiing under normai operating
conditions. However, if the dehumidifier is oper
ated under severe environmental conditions
(dust, dirt, high temperatures) the fan motor

should be oiled annually through the provided
oil tubes (holes). An easy to use capsule of es

pecially recommended oil (Part Number 10943)
is available through your nearest Whirlpool
Factory Service Center, or use SAE #20 non

detergent oil.

Wash plastic parts with a soft cloth, warm wafer

and mild detergent. Rinse and dry with a soft
cloth.

OIL FAN
MOTOR
(Back Oil
Hole Not
Shown)

Replace cabinet grille(s). Reconnect power

supply cord.