Clean it, Plug it in, Install properly – Whirlpool 6ET18GK User Manual

Page 4: Level refrigerator-freezer, Before using your refrigerator

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Before Using Your Refrigerator

3-prong grounding
type wall receptacle

3-prong
grounding plug

—-

Refrigerator
power cord '

Clean It
Clean your refrigerator before using it. See

cleaning instructions on page 10.

Plug it in

Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate circuit
serving only this appliance be provided. Use a re
ceptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.

See Electrical Requirements and Grounding

Instructions Sheet in your Literature Package.

Leveling screw

Use screwdriver

to adjust

Front roller

Install properly

1. Allow 3 inches (7.5 cm) between overhead

cabinets and refrigerator top.

2. Allow at least an inch (2.5 cm) between the

refrigerator condenser on the back and the wall.

3. Allow '/a inch (1.25 cm) on each side of the

refrigerator for ease of installation.

If the refrigerator is to be against a wall, you

might want to leave extra space on the hinge
side so the door can be opened wider.

5. If your refrigerator has an ice maker, make sure

ice maker water supply has been connected.
Refer to Installation Instructions.

Level refrigerator-freezer

1. To raise front, turn screw in direction shown.

2. To lower front, turn screw in direction shown.
3. Check with level.

Lower

Right to raise;

left to lower