beautypg.com

Caring for your washer, Care during periods of non-use, Winter storage or moving care – Whirlpool Roper RAL5144BG0 User Manual

Page 21: Non-use/vacation care, Saving energy

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

L A U N D R Y T I P S

Caring for your washer

• Wipe up detergent, bleach, and other spills with

a soft, damp cloth or sponge as they occur.

• Remove hard water deposits using only

cleaners labeled as washer safe.

• If the washer interior needs cleaning (for

example, after tinting or dyeing), put 1 cup

(250 mL) of chlorine bleach and 2 cups
(500 mL) of detergent in the washer. Run

through a complete cycle using hot water.

If staining occurs on following loads, repeat

the process.

• Sharp or heavy objects can damage your

washer. Check pockets for bolts, nuts, etc.

Do not lay these objects on your washer after

emptying pockets.

NOTE:

Operate your washer only when you

are at home.

Care during periods of non-use

Winter storage or moving care

Install and store your washer where it will not

freeze. Because some water stays in the
washer, freezing can damage it. If your washer
is stored or moved during freezing weather,

winterize it.

1. Shut off both water faucets. Disconnect the

drain water inlet hoses.

2. Put 1 quart (1 L) of R.V.-type antifreeze in

the basket.

3. Push in and turn the Cycle Control Knob

clockwise to just beyond any dot on the dial.

(See “Using rinse and spin” on page 8.)

4. Pull out the Cycle Control Knob and allow

the washer to run about 30 seconds to mix
the antifreeze and water.

5. Unplug power supply cord.

To use the washer again:

1. Flush water pipes and hoses.

2. Reconnect water inlet hoses.
3. Turn on both water faucets.
4. Reconnect power supply cord.
5. Run the washer through a complete cycle

with 1 cup (250 mL) of detergent to clean

out antifreeze.

Non-use/vacation care

1. Unplug power supply cord or turn off

electrical power.

2. Turn off water supply leading to your

washer. This will help avoid accidental
flooding while you are away (for example,
due to a water pressure surge).

Saving energy

Use warm or cold wash water for most loads.

Use hot water only when washing heavy,

greasy soils or whites.

Use cold rinses.

Wash full loads.

Use lower water levels when washing small
loads.

• Avoid rewashing. Use enough detergent;

pretreat stains or heavy soils; do not over­
load; use the cycles and wash times recom­
mended for the fabric and soil; sort properly.

• Use your washer during off-peak hours-

usually early morning and late evening. (Ask
your power company.)

21