Lighting standing pilots to light cooktop pilots, To light oven burner pilot, Lighting standing pilots – Whirlpool SF335ESR/ER User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lighting Standing Pilots
To Light Cooktop Pilots:
2.
Remove the grates and reflector
pans from cooktop. Lift the cook
top and rest on support rod.
3.
To light,
hold a lit match over the
pilot light located between the
front and back burners. The pilot
flame should be Vi to % in
(.635-.953 cm) high.
4.
If the pilot flame needs adjusf-
ment, turn the pilot adjustment
screw on the manifold pipe.
5.
Lower the cooktop and replace
the grates before using the sur
face burners.
To Light Oven Burner Pilot:
1. Make sure the oven control Is OFF.
2.
Remove the broiler drawer. Slide
drawer out to stops, lift both sides,
then slide the rest of the way out.
3.
Field a lit match over the oven
burner pilot located at the rear of
the burner.
4.
After the oven burner pilot is burn
ing steady, check burner lighting
by turning the Oven Control to a
temperature above 140°F (60°C).
The burner will take 50-60 seconds
to light.
5.
Replace the broiler drawer.
11