Whirlpool LA6800XK - Manual (Page 7)

For a Pre Wash
Use this setting for a shorter SOAK
CYCLE (no rinse). Use enough detergent
for a single wash, Ada the load
• Set the LOAD SIZE SELECTOR.
• Set water temperature, (The washer
will fill with wash
water ]
If you want high agitation and
spin, use the dot in REGULAR HEAVY, If
you want low agitation and spin, use the
dot in KNITS GENTLE, Use the dot in PER­
MANENT PRESS if you want high
agitation and a low-speed spin
For Spinning Oniy
There may be times when you
want to drain out all the wash water and
start over. To stop the washer at any
time, just push in on the Cycle Control
Knob.
• Push the Cycle Control Knob in and
turn it to the 12-minute mark in the SOAK
CYCLE.
• Pull the Control Knob out to start the
washer. See SOAK CYCLE description on
page 10, It will start after the first "SOAK
,,8 minutes"
• After filling, the washer may pause
before starting to agitate.
For Rinsing Oniy
Loads with towels, diapers, jeans
or heavily soiled items often need extra
detergent. Extra detergent can require
an extra rinse
Your washer can be set to rinse
only. Use the setting for on extra rinse, or
for laundry that only needs a rinse and
spin
%
permanent
r lOl
There is a dot just after the num­
bers in PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE, |f you push in
on the Cycle Control Knob, turn the
pointer to one of those dots and pull the
Control Knob out, the washer will fill,
agitate, drain ana spin
super wash
kB regular
^2 heavy
To set the washer so it drains and
spins water out of the load, push in on
the Control Knob, turn the dial to the
right (clockwise) so the pointer is touch-
ng the barjust before OEF in any cycle
The washer will drain, spin out
water and stop. If you want a low-speed
spin, use the bar on PERMANENT PRESS
or KNITS GENTLE, All the other cycle
settings have a high-speed spin