Whirlpool ED19TK - Manual (Page 5)

Removing Freezer Shelves
• Lift front slightly
• Lift back off
suDports
• Replace in reverse order
Lift the Front
Then the Back
Removing the Crisper, Meat Pan
and Covers...
• Slide crisper and meat pan straight out to stop
• Lift the front
• Slide the rest of the way out
• Replace in reverse order
• Covers are held in place by two pegs at the back
and two notched tabs m tront
- Press front tabs out of the way.
- Lift cover front
- Lift back off the pegs
' Replace in reverse order
Changing Light Bulbs...
Before removing a light shield for oleaning or for
replacing a bulb,
unplug the refrigerator. U s e a p ­
p l i a n c e b u l b s o n l y
Light bulbs behind refrigerator and freezer
control consoles:
- Pull control knob straight oft
- Pull bottom of control panel straight out
-- Lift top of
p a n e l o f f supports
- Replace with a 40-watt appliance bulb
- Replace panel m reverse order
Ice Cube Trays...
To remove ice:
• Hold tray at both ends.
• Slightly twist
If cubes are not used, they may shrink The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get
Optional Automatic Ice Maker...
On
If you have the automatic ice maker accessory or
plan to add one later (Part No, ECKMF-6], there are
a few things you will want to know:
• The ON/OFF lever is a wire signal arm,
Down,,,for making ice automatically:
Up., ,to shut off the ice maker,
• Shake the bin occasionally to keep cubes sepa­
rated, and to obtain increased storage capacity,
• It is normal for ice crescents to be attached by a
corner. They will break apart easily,
• You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't let
these sounds bother you,
• The ice maker will not operate until the freezer is
cold enough to make ice. This can take overnight,
• Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice,
• If ice is not being made fast enough and more ice
IS needed, turn the Temperature control to a higher
number. Wait a day and. If necessary, turn the Air
Control to a higher number,
• If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position,
• If cubes are stored too long, they may develop an
off-flavor,,,like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.