What happens in each, Cycle – Whirlpool 3396314 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
What happens in each
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita
tion starts, the Cycle Control Knob turns
clockwise until h points to OFF and the
cycle ends.
cycle
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: A Gentle Wash system helps protect
your fabrics by reducing wash agitation
speed during the last few minutes of wash
agitation in the Regular and Permanent
Press cycles.
WASH
RINSE
Fill
V
Rll
Wash*
m
Rinse
‘Agitation speed is reduced in the last few
minutes of most cycles. This provides
better fabric care.
Drain-No agitation
hsJ
Drain (or partial drain*)
No agitation
Spin-Spray rinse
*The Permanent Press cyde partially
drains, fills, agitates briefly, arKi drains.
m
Spin
1*
Spin
lA
Off
10