Water requirements, Drain requirements, Now start – Whirlpool 3369088 User Manual

Page 3: With dishwasher in kitchen

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Water

requirements

The hot water lihe to the dishwasher

must provide betweeh 15 - 120 PSI

water pressure.

The hot water heater

should be set to deliver 140°F water

temperature to the dishwasher for

best resuils.

Use 3/8" O.D. copper tubing or 1/2"
plastic tubing minimum inlet line.
Dishwasher inlet valve has 3/6"
internal pipe thread.

Drain

requirements

Drain line connection to house

plumbing must be minimum 20"

above floor to prevent siphoning.

Drain hose, supplied, meets
AHAM DW-1 test standards. Cut

1-1/2" hole in cabinet wall for drain

hose. Additional drain line, a
minimum of 1/2" I.D. and no longer
than 20 feet can be used if needed.

Now start...

with dishwasher in kitchen.

Disconnect electric supply before

installing dishwasher.

Remove the

screws

■ attaching access panel and

toe panel to dishwasher using a 1/4 "
socket wrench or Phillips screwdriver.

Remove occess panel and toe
panel.

opening. Measure height of cabinet
opening from underside of
countertop to floor. Check chart for

that height opening, Put the wheels

in the required position,

Min.

Culout

Heighl

Wheel

Position

(See

lllustrotion)

Number

Of turns

To Preadjuil

Levelers

33-7/8"

1 ' 0

34-1/16"

34-1/4-

34-7/16'

For addiNonal height:

1. Add shims under the wheels.

2. Turn front levelers (each turn adds 1/16"

in height).

Loosen and then turn front levelers

the number of times indicoted in
the chart.

Numbers

Panel B