Starting your nasher, Caution, Do not – Whirlpool LA77O0XS User Manual

Page 4: Overload washer, Select a load size ^ select water, Temperatures, Load sizes and water levels

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Starting your nasher

Before starting
your washer:

1. Measure and add detergent.

2. Place sorted load in washer.
3. Start the washer.

■ O i

INFINITE WATER SAVING

LOAD SIZE SELECTOR

Select a

LOAD SIZE

^ Select WATER

TEMPERATURES

• Turn the knob to point at a setting

that describes the size of load you
want to wash.

• Set the knob on or between EX

SMALL (a few items) and EX LARGE
(a full load).

• To change the water level after the

washer has started to fill, turn the knob
to RESET, then the desired water level.

NOTE: Use the EX LARGE water
level for best permanent press
results.

• Select wash and rinse water tem

peratures by pushing a button.

• This drawing shows a warm wash

(top temperature) and cold rinse
(bottom temperature) selection.

Recommended wash temperatures
can be found in your “Laundry Guide.”

iMPORTANT; Use warm water
with the PERM’T PRESS or KNITS/
GENTLE cycles. For heavily
soiled permanent press or knit
clothes, pre-wash or pre-soak
before washing in warm water.

LOAD SIZES AND WATER LEVELS

For best cleaning results, the

load must be able to move freely
in the water. Too big a load or too
little water can cause wear or

tearing of load items.

‘Approximate ^

fill with load.

CAUTION:
DO NOT
OVERLOAD WASHER.

EX LARGE

(17.3 gal./65.5 L)‘

(14.7 gal./55.7 L)‘

(12.1 gal./45.8 L)‘

EX SMALL

(9.5 gal./36.0 L)‘