Whirlpool SM958PES - Manual (Page 7)

Using the Surface
Burners
Control knobs must be pushed in,
then turned to the LITE position. The
clicking sound is the ignition
sparking.
To stop the clicking sound after the
burner lights, turn the control knob
back to a desired setting. The control
knob has stops for HI, MED and LOW,
however it can be set anywhere be­
tween HI and OFF. Do not cook with
the controi in the LITE position.
Surface Burner Indicators
The solid dot in the surface burner in­
dicator shows which surface burner is
turned on by that khob.
A WARNING: If the flame
should go out while cook­
ing, or if there is a strong odor,
turn the burners OFF. Wait five
minutes for the gas odor to dis­
appear, before relighting burner.
If gas odor is still present, see
safety note on page 2.
In Case of a Prolonged Power Failure
Surface burners can be manualiy lighted. Hold a lighted nnatch near a burner
and turn the control to the LITE position. After the burner lights, turn the control to
the desired setting.
A WARNING: Burner flame should not extend beyond the edge
of the cooking utensil. The flame can burn you and cause
poor cooking results.
See the “Cooking Guide” for important utensii information. Untii you get
used to the settings, use the foiiowing as a guide.
Use LITE to light
the burner. After
the burner lights,
turn control
back to a de­
sired setting.
Do not cook with
the control in
the LITE position.
Use a high
setting
to start
cooking or to
bring liquids
to a boil.
Use a medium
setting
to start
cooking or to fry
chicken or pan­
cakes; for gravy,
puddings and
icing orto cook
large amounts
of vegetables.
Use a iow set­
ting to keep
foods warm until
ready to serve.