Whirlpool LA3000XK - Manual (Page 7)

For a Pre Wash
Use this settir-,3 tcs a s^i jrter SOAK
CYCLE (no rinsej. Use e-'-oug'' detergent
for a single -.vash Aiie *he ood
• Set -A-ash Aater teA,;:.i-ri.]i,j'-^
Por high agitation and spin
speeds, use the asterisk in the
(LEGULAR HEAVY Cycle, ^he KNIT
GENTLE Cycle has low agitation and
spin speeds
The washer fills with cold water.
Water level and temperature can't
be adjusted In this setting
• Push the Cycle Comroi Knoo in and
turn it to the 12-minute mark ir' the SOAK
CYCLE,
• Pull the Control Knob out to start the
washer,
• The washer will fill agitate for two
minutes, soak for eight minutes, agitate
for two more, and then drain and spin,
(See SOAK CYCLE description on page
8.]
• After filling, the washer may pause
before starting to agitate.
For Spinning Oniy
There may be times when you
A'Cnt to drain out all the wash water and
start over. To stop the washer at any
time, just push in on the Cycle Control
Knob,
^
For Rinsing Only
Loads with towels, diapers, jeans
or heavily soiled items often need extra
detergent. Extra detergent can reguire
an extra rinse
Your washer can be set to rinse
only Use the setting for an extra rinse, or
for laundry that only needs a rinse and
spin
To set the washer so it drams and
spins water out of the load, push in on
the Control Knob, turn the dial to the
right (clockwise) so the pointer is touch-
ng the bar just before CEE in any oycle.
The washer will dram, spin out
woter and stop
There IS an asteriskj ) just after
the numbers in two cycles. If you push in
on the Cycle Control Knob, turn the
pointer to one of those asterisks and pull
the Control Knob out, the washer will
fill, agitate, drain and spin