Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.

Before starting your washer

Add measured detergent. Then place a sorted NOTE: If your washer has a Consumer Buy

load in the washer before starting. See page 14 Guide, remove it and place it in your Use and

for additional “Before you wash” information. Care Guide.

Knits Gentle

k Woollens

Permanerli

Press

Starting or stopping your washer

starting your washer:

1. Push in the Cycle Control Knob and turn it

clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are

minutes of wash time.

2. Select a load size and water temperature.
3. Pull out the Cycle Control Knob.
Refer to pages 6-10 for additional information
to help you make selections.

Stopping and restarting your washer:
• To stop the washer at any time, push in the

Cycle Control Knob.

• To restart the washer, close the lid (if neces

sary) and pull out the Cycle Control Knob.

Manual

Soak

Auto Soak

Selecting a load size

Your washer has a knob or slide Load Size
Selector. Position the Load Size Selector at the
setting that corresponds to the size load you
want to wash.

Select a load size based upon the size of the

load and the fabric you are washing. See
page 14 for additional loading information.
• If your washer has a knob Load Size Selec

tor, turn selector to the desired load size.

Imall Lare

/Ri

Ex Large

Settings may vary with modei