Whirlpool EHl5EF - Manual (Page 4)

Install properly...
2
,
4.
5.
Check with level
. .»«--’S'. laacrLMawt'ifti
Install defrost drain cover...
1. Remove cover from literature package.
2. Check drawing on front cover for placement,
3. Install cover.
Clean it...
Clean your freezer before
using it. See cleaning
instructions on page6.
Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
Pick a safe place, indoors, away from in­
flammables such as gasoline.
Allow at least 3 inches (7.5 cm) air space on all
sides of freezer and 2 inches [5 cm) at back. Leave
room at top for lid to open all the way.
It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad­
justment, see your authorized WHIRLPOOL dealer.
Do not cover the freezer with items such as
blankets, sheets, tablecloths, etc.
Plug it in...
3-prong grounding
type wall receptacle
Retaining Clip
Level ehest freezer...
from end to end and front to back so that the lid will
seal properly.
Power Plug 3-prong
grounding plug
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1,
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Care & Service label
on inside lid or Tech Sheet on back ot cabinet.
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Use a
receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.