Whirlpool LE4900XK - Manual (Page 6)

FLUFF AIR
This setting is useful for fluffing
bedding, pillows and clothing, or dust­
ing drapes. It is also best to use when
damp-drying heat-sensitive items
Drying plastic or rubber items
with heat may damage the
items or be a tire hazard.
The AIR Cycle should be used for
such Items as plastic shower curtains
or tablecloths, rubber-backed rugs,
some pillows, stuffed toys, etc
• Turn the Cycle Control Knob to the
AIR Cycle
• Push the Start Button
Tlimbling to
Remove
Wrinkles
When permanent press and syn­
thetic knits are wrinkled from packing in
suitcases or crowded in closets, your
dryer can help put them back Into their
pre-set shape
• Set Cycle Control Knob to PERMA­
NENT PRESS for 20 minutes.
• Push the Start Button
• For best results, tumble only a few
Items at a time; put them on hangers or
fold them as soon as the dryer stops.
Lint Screen
The lint screen is inside the dryer
drum, on the back wall. Clean if before
each load. A screen that's blocked by
lint can cause longer drying times.
CAUTION: Do not operate
the dryer with the lint
screen removed or not
securely in place as it
may cause overheating,
possible damage to fab­
rics and dryer parts or
create a fire hazard.
• Pull straight out oh the lint screen by
using the two finger holes.
• Sgueeze lightly on the body of the
lint screen and pull the cover off
• Roll the lint off the screen with your
fingers DO NOT rinse the screen '
or wash it. Wet lint is hard to remove.
• Replace the cover on the body of
the lint soreen. Then push it straight
back into place. You will hear a click
when the lint screen snaps into place.
End-of-Cycle
Signal
A signal will let you know that the
dryer has stopped.
The signal is helpful when you are
drying permanent press, synthetics
and other items that really should be
taken out as soon as the dryer stops.
The signal can't be turned off and
it is not adjustable