Whirlpool ED22DC - Manual (Page 17)

U S I N G Y O U R R E F R I G E R A T O R
Solving common ice maker/dispenser
problems
PROBLEM CAUSE SOLUTIONS
Ico dispenser • Freezer door open • Close the freezer door.
won’t work
• Ice bin not property
installed
• Make sure bin is pushed in all the way.
• Wrong ice in bin • Use only crescents from Ice maker.
Shake the bin occasionally to keep cubes
separated and to increase storage room.
• Dispenser not used for
extended periods,
causing ice cubes to
melt together
• Dump old ice and make a new supply.
Ice dispenser • Ice dispenser bar held • Wait about 3 minutes for the dispenser
stops working in too long motor to reset.
• Large amounts of ice should be taken from
the bin, not through the dispenser.
Off-taste or • Ice attracts airborne • Dump old ice and make a new supply.
odor In Ice odors; old ice Store excess ice in covered container.
• Water quality • Water containing minerais (such as sulfur)
may require a filter to remove.
• Good water quality is important for good
ice quality. Try to avoid connecting the ice
maker to a softened water supply. Water
softener chemicals (such as salt from a
malfunctioning softener) can damage the
ice maker mold arxl lead to poor ice
quality. If a softened water supply cannot
be avoided, make sure the water softener
is operating properly and well maintained.
• Foods not properly
wrapped
• Wrap properly. See pages 24 and 25.
• Ice bin and freezer may • Clean freezer and ice bin. See cleaning
need cleaning chart on pages 21 and 22.
• Plumbing to ice maker • Follow Installation instructions for proper
ice maker water suppiy hook up. (See
back of refrigerator cabinet.)
• New ice maker • The first few loads of ice from a new ice
maker may have an off-taste. Dump ice
and make a new supply.
17