Whirlpool EB19ZK - Manual (Page 8)

Optional automatic ice maker...
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-62), there are a
few things you will want to know:
• The ON/OFF lever is a wire signal arm.
Down...fa making ice automatically:
Up...to shut off the ice maker.
• Shake the bin occasionally to keep cubes sepa­
rated, and to obtain increased storage capacity.
Lower Signal
Arm fo Start It
Raise Signal
Arm to Stop Ice Maker.
' It is namal fa ice crescents to be attached by a
corner. They will break apart easily.
' You will hear water running when ice maker is
waking. You'll hear ice fall into the bin. Don't let
these sounds bother you.
' The ice maker will not operate until the treezer is
cold enough to make ice. This can take overnight.
' Because of new plumbing connections, the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
I If ice is not being made fast enough and mae ice
is needed, turn the Temperature Control toward a
higher number. Wait a day and, if necessary, turn
the Air Control toward A.
I If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
position.
I If cubes are stored too long, they may develop an
off-flavor... I ike stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
' Good water quality is important for good ice quality.
It is not recommended that the ice maker be con­
nected to a softened water supply. Water softener
chemicals such as salt from a malfunctioning soft­
ener can damage the ice maker mold and lead to
poor quality ice. If a softened water supply cannot
be avoided, then it is important that the water soft­
ener be well maintained and operating properly.
Sounds you may hear...
Your new refrigerator may make sounds that your old one didn't.
Because the sounds are new to you, you might be concerned about
them. Don't be. Most of the new sounds are normal. Flard surfaces like
the floor, walls and cabinets can make the sounds seem louder.
The following chart describes the kinds of sounds that might be new
to you, and what may be making them.
Possible Sounds:
• Slight Hum, Soft Hiss: Probable Causes:
You may hear the refrigerator's fan motor and moving air.
• Clicking or Snapping
Sounds:
The defrost timer makes a definite click when the refrigerator stops running. It
also makes a sound when the refrigerator starts.
Water Sounds:
• Ice Maker Sounds:
-trickling water
-thud (clatter of ice)
When the refrigerator stops running, you may hear gurgling in the tubing for d
few minutes after it stops. You may also hear defrost water running into the
defrost water pan.
If your refrigerator has an ice maker, you may hear buzzing (from the water
valve], trickling water and the clatter of ice dumped into the bin.
• Running Sounds: Your refrigerator has a high-efficiency compressor and motor. It will run longer
than older designs. It may even seem to run most of the time.
Energy saving tips...
You can help your refrigerator use less electricity.
• Check door gaskets for a tight seal. Level the cabi­
net to be sure of a good seal.
• Clean the condenser coil regularly.
• Open the door as few times as possible. Think about
what you need before you open the door. Get
everything out at one time. Keep foods organized
so you won't have to search for what you want.
Close door as soon as food is removed.
• Go ahead and fill up the refrigerator, but don't over­
crowd it so air movement is blocked.
It is a waste of electricity to set the refrigerator and
freezer to temperatures colder than they need to
be. If ice cream is firm in the freezer and drinks are
as cold as your family likes them, that's cold enough.
Keep the Power Saving Control on OFF unless
moisture forms on the refrigerator exterior.
Make sure your refrigerator is not next to a heat
source such as a range, water heater, furnace, radi­
ator, or in direct sunlight.
8