What happens in each cycle, Operating your washer – Whirlpool Roper RAL6245BL0 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATING YOUR WASHER
What happens in each cycle
After agitation starts, the Cycle Control Knob
turns clockwise until It points to OFF and the
cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to the
selected load size) before agitation and timing
start. The washer will begin agitating immedi
ately after filling; agitation can occur with the
washer lid up or down.
NOTE: Wash agitation speed is reduced
during the last few minutes of wash agitation in
the Heavy, Regular, and Permanent Press
cycles. This helps protect your fabrics.
WASH
RINSE
...
Fill
Fill
№
1 Wash selected time
Rinse
Drain (or partial drain*)
No agitation
Drain-No agitation
'The Permanent Press cycle partially
Spin-Spray rinse
drains, fills, agitates briefly, and drains.
1A
Spin
Spin
Off