Other operating instructions, For a rinse and spin, For a soak or pre-wash – Whirlpool LA68OOXP User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de
tergent can require an extra rinse.)
• Push Control Knob in.
• Turn clockwise to any »on the dial.
See above drawing.
• Pull Control Knob out.
• The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin cutwater.
• Push Control Knob In.
• Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
• Pull Control Knob out.
• The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6-9.
For a soak or pre-wash
10
For best results, use
warm
water
for soaking or pre-washing stained
laundry.
Hot water can set stains.
• Use recommended amount of
detergent or pre-soak product.
• Push Control Knob in.
• Turn clockwise to point at a
number
in the Soak Cycle * ...use the 4-minute
mark for a pre-wash.
• Pull Control Knob out to start washer.
• When the cycle is over, add de
tergent for the next selected wash
cycle.
The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide.”
• Set the washer and start the next
selected wash cycle.
*To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.