Whirlpool LSS7233DQ0 - Manual (Page 9)

O P E R A T I N G Y O U R W A S H E R
Reusing your wash water
Your storage tub holds the wash water from
your last wash load. The soils in the wash
water settle to the bottom of the storage tub
and remain in the storage tub when the wash
water is pumped back into the washer. Drain
the storage tub after the wash water is
pumped back into the washer.
1. Set the Cycle Control Knob to SUDS
RETURN. Do not add load items at this
time.
2. Pull out the Cycle Control Knob. The
washer pumps most of the wash water
from the storage tub back into the washer
basket.
3. When Suds Return is complete, push in
the Cycle Control Knob.
4. Add about V 2 the recommended amount of
detergent and your wash load.
5. Turn the Cycle Control Knob clockwise to
the desired cycle and wash time.
6. Pull out the Cycle Control Knob to start the
washer.
7. Drain the storage tub.
Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may find an extra rinse and spin is needed.
1. To add an additional rinse, push in the
Cycle Control Knob and turn clockwise to
RINSE, as illustrated.
2. Pull out the Cycle Control Knob. The
washer fills to selected load size,
agitates, drains, and spins.
Using drain and spin
A drain and spin may help shorten drying
times for some heavy fabrics or special-care
items by removing excess water.
1. Push in the Cycle Control Knob and turn
clockwise to SPIN, as illustrated.
2. Pull out the Cycle Control Knob. The
washer drains, then spins.