Whirlpool 3376809 - Manual (Page 22)

Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It could
save you the cost of a service call.
Dishwasher problems
PROBLEM CHECK THE FOLLOWING
Dishwasher does
not run or stops
during a cycle Is the door tightly closed and securely latched?
Has the cycle been set correctly? See pages 5 and 12.
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper voltage?
Dishwasher
will not fill
Is overfill protector stuck in “up” position? Overfill protector should
move up and down freely. Press down to release. See page 17.
Water remains
in dishwasher
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer's cleaning instructions.
Detergent remains
in covered section
of dispenser Has the cycle completed?
Is the detergent fresh and dry without lumps? See page
10
.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry
as you expected
Is the rinse agent dispenser empty? Using a rinse agent greatly
improves drying. See page 11.
Do not use ENERGY SAVER DRY option. See page 13.
White residue
appears on front Is too much detergent being used? See page 10 for recommended
amounts of detergent.
of access panel
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
Dishwasher will
not close Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
22