CHEVROLET 2009 Silverado - Manual (Page 19)

6. Secure the buckles by
folding them once, then
slide them under the
cord located on
the cover.
Removal
1. To remove the cover,
open the tailgate and
pull the rear cord to the
right.
2. From the driver side, roll the cover up tightly.
3. After the cover is rolled up, secure both tie-down
straps by pulling them tightly.
4. Secure the cover into the open position.
5. On the passenger side, release the Velcro ® from
the side rail.
6. Then pull the front cord to the right. This releases
the cover assembly from the side rail.
7. Pick the cover assembly up on the driver side and
pull the whole assembly off the truck box.
Adjustment
1. If the cover is tight, turn
the tensioning screw
counter clockwise to
loosen the tension of
the vinyl. This makes it
easier to operate the
rear release latch. The
tensioning screws are
located on each side
rail. Use the provided
1/4 inch key to turn the
tensioning screws.
2. Adjust the screws on both sides to the same
tension.
2-11