Champion Power Equipment 90720 - Manual (Page 11)

REV 90720-20131010
8
90720 ENGLISH
ASSEMBLy
Your log splitter requires some assembly.
If you have any questions regarding the assembly of your
log splitter, call our help line at 1-877-338-0999. Please
have your serial number and model number available.
Open Shipping Crate
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of
shipping crate.
3. Locate all hardware before beginning assembly.
1) Install the Wheels to the Wheel Mount
1. Slide the wheel onto the wheel mount.
2. Slide washer (#38) and snap ring (#39) onto the
wheel mount bolt.
3. Repeat steps 1 and 2 for other wheel
2) Install the Support Foot
1. Align the Support Foot with the mounting holes
under the beam
2. Place the bolt through the hole
3. Place a washer and lock washer on the end of the
bolt.
4. Install the nut on the bolt and tighten. Do not over
tighten.
3) Install the Beam onto the Wheel Mount
1. Align the 4 threaded blocks on the back of the beam over
the 4 larger holes on the side of the wheel mount.
2. Thread an M10x20 bolt (#34) through a M10 washer
(#22).
3. Thread the bolt and washer under the wheel mount up into
the small blocks on the back of the beam and tighten.
4. Repeat steps 1-3 for the remaining 3 bolt and washer sets
to complete the mounting of the beam to the wheel mount.
4) Install the Engine to the Wheel Mount
1. Align the 4 holes on the base of the engine with the
4 smaller holes on the wheel mount.
2. Thread an M8x20 bolt (#36) through an M8 lock
washer (#26) and M8 washer (#27).
3. Thread a bolt and washers set through a hole on the
bottom of the wheel mount into the engine and tighten.
4. Repeat steps 1-3 for the remaining 3 bolt and
washer sets to complete mounting of the engine to
the wheel mount.
The snap ring requires snap ring pilers (O.D.).
Available at hardware and auto part stores.
NOTE
The beam should extend to the opposite side of the
wheel mounts as shown.
NOTE
The recoil side of the engine should point the same
direction as the beam as shown.
NOTE