Carl Goldberg GBGA1044 - Manual (Page 21)

21
Receiver and Switch Installation
1. The switch can be mounted in any convenient
location. The sheeted part of the fuselage just
below the sides work really well.
2. A mount for the receiver is provided just
behind the servo tray and under the rudder
cables.
Do not glue the canopy to the hatch without the
hatch mounted to the fuselage. You can warp it
and it will not fit back on the fuselage.
1. Mount the hatch to the fuselage using the two
4-40 x 1/2” screws.
Put a piece of wax paper between the tur-
tledeck and canopy bulkhead to prevent glue
from getting in the seam.
. Put a bead of canopy glue around the edge of
the canopy on the inside and fit into place.
Make sure canopy is properly positioned and
hold in place with masking tape till glue dries.
Most canopy glues can be cleaned up with
water while still wet. Check the glue
instructions Remove any smudges with a
damp cloth.
A strip of clear vinyl tape around the edge of
the canopy will assure that it does not come
loose. 3M makes a clear that can be pur-
chased at most hardware stores.
Canopy Mounting.