Caution – Cadillac 2004 XLR User Manual
Page 285
When rotating your vehicle’s tires, always use the
correct rotation pattern shown here. After the tires have
been rotated, adjust the front and rear inflation
pressures as shown on the tire and loading information
label, see
Inflation - Tire Pressure on page 5-57 and
Loading Your Vehicle on page 4-32. Vehicles equipped
with the Tire Pressure Monitor (TPM) system will
need to have the sensors reset after a tire rotation is
performed. A special tool is needed to reset the sensor
identification codes. See your dealer for service.
Make certain that all wheel nuts are properly tightened.
See
Wheel Replacement on page 5-66 and “Wheel
Nut Torque” under
on page 5-91.
{
CAUTION:
Rust or dirt on a wheel, or on the parts to
which it is fastened, can make wheel nuts
become loose after a time. The wheel could
come off and cause a crash. When you change
a wheel, remove any rust or dirt from places
where the wheel attaches to the vehicle. In an
emergency, you can use a cloth or a paper
towel to do this; but be sure to use a scraper
or wire brush later, if you need to, to get all the
rust or dirt off.
5-61