Cadillac 2011 DTS - Manual (Page 266)

Black plate (108,1) Cadillac DTS Owner Manual - 2011
If an unwanted number is recognized by the system,
say “Clear” at any time to clear the last number.
To hear all of the numbers recognized by the system,
say “Verify” at any time.
1. Press and hold b g for two seconds.
2. Say “Digit Dial.”
3. Say each digit, one at a time, that you want to dial.
After each digit is entered, the system repeats
back the digit it heard followed by a tone. After the
last digit has been entered, say “Dial.”
Once connected, the person called will be heard
through the audio speakers.
Using the “Re‐dial” Command
1. Press and hold
b g
for two seconds.
2. After the tone, say “Re‐dial.”
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
. Press b g to answer the call.
. Press
c x
to ignore a call.
Call Waiting
Call waiting must be supported on the cell phone and
enabled by the wireless service carrier.
. Press b g to answer an incoming call when
another call is active. The original call is placed
on hold.
. Press
b g
again to return to the original call.
. To ignore the incoming call, no action is required.
. Press
c x
to disconnect the current call and
switch to the call on hold.
Three‐Way Calling
Three‐way calling must be supported on the cell phone
and enabled by the wireless service carrier.
1. While on a call, press b g .
2. Say “Three‐way call.”
3. Use the dial or call command to dial the number of
the third party to be called.
4. Once the call is connected, press
b g
to link all
the callers together.
Ending a Call
Press c x to end a call.
4-108