Burris Veracity User Manual

Page 5

NOTE: Windage adjustments are
made with a multi-direction
adjustment knob. Zero is set with
an indexing mark to allow for left
and right adjustments. Failure to
zero at the index mark may result
in limited windage adjustment.

Windage/Elevation Adjustment for E1 Hunter Knobs
– Applies to 2x-10x and 3x-15x models –
The low profile E1 Hunter Knobs feature a finger
adjustment for both windage and elevation. Once you
have successfully zeroed your scope, you can set the
zero on your dials with these simple steps:

1) With turret caps removed, grip knob top firmly and keep

knob from turning.

2) Put pen or other small

object into the small hole
located on the dial.

3) Keeping firm grip on the

knob, use the pen to turn
the dial back to zero, lining
up the number zero with
the white indicator dot.
Only the numbered dial
should move – do not allow
the entire knob to move or
else you will alter your windage

and elevation zero settings.

NOTE: You do not have to set the zero on your dials for
your scope to function properly. Doing so can give you
peace of mind that your zero is set, plus you can easily
confirm if it has moved at any time, but this step is
optional.

Proper Windage Zero