Bullet Tools 213-SID - Manual (Page 4)

4
Item E
SEt Up
3. ATTAcH TAblE
A. Attach front of table to base,
using Item D screws. Tighten
with #3 Phillips.
B. Attach back of table to tail
using Item E self tapping screws.
Tighten with #2 Phillips.
4. TO ATTAcH HAnDlE:
Insert Item F screws and tighten with 1/2”
(13mm) wrench.
Note: To ensure correct alignment, start each of
the bolts by hand before using wrench.
5. ATTAcH FEncE
Attach fence in one of the two hole sets on
the table: one at 90° and one at 45°. Use Item G
screws with Item H wingnuts to fasten securely.
3
3b
4
5
3A
Item D
Item F
Item G
Item H
Tail