Buick 2002 Rendezvous - Manual (Page 213)

2-121
Tilt Mirror
The tilt mirror feature can be programmed to one of the
following modes:
ON: The passengers side outside rearview mirror will
tilt down towards the curb when the vehicle is shifted to
REVERSE (R) and returns to its previous position when
the vehicle is shifted out of REVERSE (R).
OFF: The mirror will not tilt.
To determine the mode to which your vehicle is
programmed or to program your vehicle to a different
mode, do the following:
1. Follow the instructions for “Entering Programming
Mode” listed previously.
2. Press the MODE button until TILT appears on
the DIC.
3. Press the SET button until the arrow is before
ON or OFF.
The mode you selected is now set. You can either exit
programming mode by following the instructions later in
this section or program the next feature available on
your vehicle.
Exiting Programming Mode
To exit programming mode, do one of the following:
D Shift out of PARK (P),
D turn the ignition key out of ON, or
D do not program any commands for one minute while
in the programming mode.
The programming mode message will turn off to let you
know that you are no longer in the programming mode.
Once you have reached the end of the personalization
features, PERSONALIZATION SELECTION DONE
will appear briefly. Then PRESS SET TO EXIT MODE
TO CONTINUE will appear. Pressing SET will exit you
out of the DIC. Pressing MODE will take you to the
beginning of personalization.