Buick 2005 Terraza - Manual (Page 209)

AUTO
n
(Automatic Volume): With automatic
volume, the audio system will adjust automatically to
make up for road and wind noise as you drive, by
increasing the volume as vehicle speed increases.
Set the volume at the desired level. Press this button to
select AUTO VOLUME MIN, AUTO VOLUME MED,
or AUTO VOLUME MAX. Each higher setting will
provide more volume compensation at faster vehicle
speeds. To turn automatic volume off, press this button
until AUTO VOLUME OFF appears on the display.
If your vehicle has the Bose ® audio system, it includes
Bose ® AudioPilot ® noise compensation technology.
When turned on, AudioPilot ® continuously adjusts the
audio system to compensate for background noise, so
that your music always sounds the same at the set
volume level. This feature is most effective at lower radio
volume settings where background noise can affect how
well you hear the music being played through your
vehicle’s audio system. At higher volume settings, where
the music is much louder than the background noise,
there may be little or no adjustments by AudioPilot
® .
To use AudioPilot ® , set the radio volume to your desired
level. Turn AudioPilot ® on by pressing the automatic
volume button until AVOL ON appears on the display.
As you increase vehicle speed, the background noise in
your vehicle will increase. AudioPilot
® will adjust your
audio system’s output for the background noise it hears.
To turn AudioPilot ® off, press the automatic volume
button until AVOL OFF appears on the display. For
additional information on AudioPilot
® , please visit
www.bose.com.
MUTE: Press this button to silence the system.
Press this button again to turn the sound on.
This button is not available on the Radio with
Six-Disc CD.
Finding a Station
BAND: Press this button to switch between FM1, FM2,
AM, or XM1 or XM2 (if equipped). The display will
show the selection.
O
/ e (Tune): Turn this knob to select radio
stations.
t
SEEK
u
: Press the right or the left arrow to go to
the next or to the previous station and stay there.
The radio will only seek stations with a strong signal
that are in the selected band.
t
SCAN
u
: Press and hold either arrow for two
seconds until FREQUENCY SCAN appears on
the display. The radio will go to a station, play for a
few seconds, then go on to the next station. Press either
arrow again to stop scanning.
3-79