beautypg.com

Dic vehicle customization, Dic vehicle customization -59 – Buick 2009 Enclave User Manual

Page 177

background image

TRANSMISSION HOT IDLE
ENGINE

Notice: If you drive your vehicle
while the transmission fluid is
overheating and the transmission
temperature warning is displayed
on the instrument panel cluster
and/or DIC, you can damage the
transmission. This could lead to
costly repairs that would not be
covered by your warranty. Do not
drive your vehicle with overheated
transmission fluid or while the
transmission temperature warning
is displayed.

This message displays and a chime
sounds if the transmission fluid in the
vehicle gets hot. Driving with the
transmission fluid temperature high
can cause damage to the vehicle.
Stop the vehicle and let it idle to
allow the transmission to cool.
This message clears when the fluid
temperature reaches a safe level.

TURN SIGNAL ON

This message displays and a chime
sounds if a turn signal is left on
for 3/4 of a mile (1.2 km). Move the
turn signal/multifunction lever to
the off position.

WASHER FLUID LOW ADD
FLUID

This message displays when
the windshield washer fluid is low.
Fill the windshield washer fluid
reservoir as soon as possible. See
Engine Compartment Overview on
page 5-10
for the location of the
windshield washer fluid reservoir.
Also, see Windshield Washer Fluid
on page 5-25 for more information.

DIC Vehicle
Customization

Your vehicle may have
customization capabilities that
allow you to program certain
features to one preferred setting.
Customization features can only be
programmed to one setting on the
vehicle and cannot be programmed
to a preferred setting for two different
drivers.

All of the customization options may
not be available on your vehicle.
Only the options available will
be displayed on the DIC.

The default settings for the
customization features were set
when your vehicle left the factory,
but may have been changed
from their default state since then.

The customization preferences
are automatically recalled.

To change customization
preferences, use the following
procedure.

Instrument Panel

3-59