beautypg.com

Specifications for your new v-12r power amplifier – Cary Audio Design CAD-280SA User Manual

Page 2

background image

Specifications for your newV-12R power amplifier.

We have updated the V-12 mono and stereo models to a RACING (R) version! The
new racing input circuit makes the input sensitivity 1.2 volts, similar to most
components currently available. Operating the power amplifier is a simple procedure.
Each unit is designed for long term stability in virtually any home operating situation.
Please note, if the unit is operated outside the parameters outlined in this owner's
manual, damage may result. Please read this manual carefully before putting your new
V-12R in operation. The following definitions are applicable. Warnings should be
followed explicitly.

1.2 Specifications

The CAD-280 SA V-12R or V-12R Monobloc version basic specifications:

DIMENSIONS:

9’’H x 12 _’’W x 20’’D

WEIGHT:

68-lb. stereo or 85-lb. for the Monobloc version

CIRCUIT TYPE:

Push-Pull Triode or Ultra-linear Amplification in Pure Class A

POWER OUTPUT:

50 watts – Triode Mode

100 watts – Triode (Mono)

100 watts – Ultralinear Mode

200 watts – Ultralinear (Mono)

INPUT SENSITIVITY:

1.3 volts for full output

INPUT IMPEDANCE:

150,000 ohms

NOISE AND HUM:

> 84db below rated output

FREQUENCY RESPONSE:

20Hz to 23Khz +/- 1.0 dB (at full power)

TUBES:

2- 12BZ7 Input tubes (or 12AY7, 12AX7)

2- EL-84 Current Source tubes (or 6BQ5)

12- EL-34 Output tubes (or 6550, KT-66, KT-77, KT-88, KT-

90, 6L6)

POWER TRANSFORMER:

1- EI laminated, 200% duty cycle

OUTPUT TRANSFORMERS:

2-EI laminated stereo (1-EI mono) Silicon Impregnated

RESISTORS:

1.0% tolerance, precision metal film resistors

CAPACITORS:

Oil Filled

POWER SUPPLY CAPACITORS: 4 - 560 MFD @ 400 volts

AC CORD:

3 conductor shielded detachable

AC POWER REQUIREMENTS:

117/234 volts AC 50/60Hz

POWER CONSUMPTION:

420 watts in operation, 10 watts in stand-by

WARM-UP TIME:

3 minutes

BREAK-IN PERIOD:

100 hours of music playing time

FINISH:

Jaguar Carnival Red paint on chassis

FRONT PANEL:

Machined, Black Anodized aluminum

Specifications are subject to improvement without notice or obligation.

WARNING

HAZARD PRESENTS PERSONAL INJURY OR DEATH

Caution

EQUIPMENT DAMAGE MAY OCCUR BUT NOT PERSONAL INJURY

Note

Proper performance of the amplifier cannot be ensured

if disregarded