BlackVue DR750LW-2CH V.3.00 - Manual (Page 17)

BLACKVUE LCD I 17
6
Organize the cables, using the cable clip, to prevent the driver's vision from
being interrupted.
7
Start-up of the vehicle, then check if the product is properly operating.
8
Adjust the camera angle to view the LCD screen. Slightly unfasten the cam-
era angle control bolt to adjust the angle; then fasten the bolt. Even if the
prop is detached, the camera angle can be maintained. Thus, the camera
can be installed at the same lens angle as before.
Caution
y Do not remove the microSD card while it is saving or reading data. This
may cause data damaged or malfunction.
y If BlackVue is used for the first time, set time in Settings first. (Page 29)
Note
y After a test drive, check if the video has been properly recorded.
y The recorded video is saved in MP4 format.
PLEASE CONNECT REAR CAMERA FIRST BEFORE CONNECT THE POWER
CORD ON FRONT CAMERA.